Meaning
Thermal treatment process applied to a machined part to remove entrapped gases or volatile impurities from the material structure. After a block of metal or ceramic undergoes material removal, post-milling degassing prevents the slow release of these gases during subsequent operation in a vacuum. This is important for components used in satellite housings or ultra-high vacuum chambers where outgassing can contaminate sensitive sensors.
The process usually involves heating the part to a temperature below its annealing point while under a high vacuum.
Contamination Control
Residual oils and coolants used during the cutting process can migrate into the microscopic pores of the material. During post-milling degassing, the elevated temperature increases the vapor pressure of these contaminants, allowing them to be pulled out and evacuated by the vacuum pumps. If this step is skipped, the molecules may later condense on optical surfaces or cause electrical arcing in high-voltage modules.
Cleanliness levels are monitored using residual gas analyzers that detect the presence of hydrocarbons or water vapor during the bake-out.
Process Parameter
Temperature and duration of the cycle are selected based on the material type and the final application of the component. For aluminum housings, the post-milling degassing might occur at a lower temperature over a long period to avoid changing the mechanical properties of the alloy. In contrast, stainless steel parts can withstand higher heat to drive out hydrogen molecules trapped deep within the grain boundaries.
The pressure in the furnace is kept at a level where the mean free path of the molecules is longer than the dimensions of the part.
Validation Measurement
Verification of the effectiveness of the treatment is done through a rate-of-rise test. The chamber is isolated from the pumps, and the pressure increase is measured over time to calculate the final outgassing rate of the assembly.