Meaning
Physical dimension of a conductor trace routed on the outer layer of a printed circuit board over a single reference plane determines the characteristic impedance of the transmission line. This physical dimension, known as the microstrip line width, is designed to match the source and load impedance of connected RF or high speed digital components. The parameter is defined by the copper thickness and the height of the dielectric layer separating the trace from the reference plane.
It governs the electrical performance of the outer routing layers in multi-layer board designs.
Impedance Control
Trace geometry directly dictates the capacitance and inductance per unit length of the transmission line. Decreasing the microstrip line width increases the characteristic impedance by reducing trace capacitance to the reference plane. Conversely, a wider trace increases capacitance and lowers the impedance.
Precise control of this dimension is essential to minimize signal reflections at component terminals.
Manufacturing Limitation
Etching processes during circuit board fabrication can cause trace width variations across a panel. These variations change the microstrip line width from its nominal design value and introduce impedance mismatch. Over-etching reduces trace width, while under-etching leaves the trace wider than specified.
Advanced fabricators monitor chemical concentrations to maintain trace dimension uniformity.
Layout Optimization
Board designers adjust trace routing to balance signal loss against density requirements. This trade off determines the routing pitch.