Meaning
Non-linear relationship between current and voltage at a conducting interface indicates the presence of a thin insulating barrier or semiconductor junction. This non-ohmic contact resistance occurs when metal surfaces are separated by a thin oxide layer, causing conduction to rely on quantum tunneling or breakdown mechanisms. The electrical resistance of such an interface varies with the applied voltage rather than remaining constant.
This behavior is a common failure mode in aged or contaminated electrical connectors and printed circuit boards.
Physical Origin
Oxidation and atmospheric contamination form a thin dielectric film over the metal contact points. When the voltage across this film is low, the flow of electrons is severely restricted.
System Consequence
Signal degradation occurs as this non-linear behavior introduces passive intermodulation into high-frequency communication channels. High-power transmit signals mix at the non-linear contact interface, generating spurious signals that can block weaker receive channels. This disruption degrades the signal-to-noise ratio and forces the system to reduce its data transmission rate.
In power lines, it can also lead to localized heating as the resistance fluctuates with current spikes.
Diagnostic Detection
Engineers detect this non-linear resistance by performing current-voltage sweeps or measuring intermodulation products. A standard multimeter may fail to identify the issue because its test voltage can temporarily puncture the thin oxide film and give a false reading of low resistance. Special test protocols use low-voltage sweeps to ensure the oxide layer is not bypassed during testing.
This method reveals the true state of the contact interface before the equipment is deployed.